Freescale Semiconductor MCF51QE128RM Answering Machine User Manual


 
MCF51QE128 MCU Series Reference Manual, Rev. 3
300 Freescale Semiconductor
Get the latest version from freescale.com
15.2.3 SCI Control Register 2 (SCIxC2)
This register can be read or written at any time.
1
PE
Parity Enable. Enables hardware parity generation and checking. When parity is enabled, the most significant bit
(msb) of the data character (eighth or ninth data bit) is treated as the parity bit.
0 No hardware parity generation or checking.
1 Parity enabled.
0
PT
Parity Type. Provided parity is enabled (PE = 1), this bit selects even or odd parity. Odd parity means the total
number of 1s in the data character, including the parity bit, is odd. Even parity means the total number of 1s in
the data character, including the parity bit, is even.
0 Even parity.
1 Odd parity.
76543210
R
TIE TCIE RIE ILIE TE RE RWU SBK
W
Reset00000000
Figure 15-8. SCI Control Register 2 (SCIxC2)
Table 15-4. SCIxC2 Field Descriptions
Field Description
7
TIE
Transmit Interrupt Enable (for TDRE)
0 Hardware interrupts from TDRE disabled (use polling).
1 Hardware interrupt requested when TDRE flag is 1.
6
TCIE
Transmission Complete Interrupt Enable (for TC)
0 Hardware interrupts from TC disabled (use polling).
1 Hardware interrupt requested when TC flag is 1.
5
RIE
Receiver Interrupt Enable (for RDRF)
0 Hardware interrupts from RDRF disabled (use polling).
1 Hardware interrupt requested when RDRF flag is 1.
4
ILIE
Idle Line Interrupt Enable (for IDLE)
0 Hardware interrupts from IDLE disabled (use polling).
1 Hardware interrupt requested when IDLE flag is 1.
3
TE
Transmitter Enable
0 Transmitter off.
1 Transmitter on.
TE must be 1 to use the SCI transmitter. When TE is set, the SCI forces the TxD pin to act as an output for the
SCI system.
When the SCI is configured for single-wire operation (LOOPS = RSRC = 1), TXDIR controls the direction of
traffic on the single SCI communication line (TxD pin).
TE can also queue an idle character by clearing TE then setting TE while a transmission is in progress. Refer to
Section 15.3.2.1, “Send Break and Queued Idle” for more details.
When TE is written to 0, the transmitter keeps control of the port TxD pin until any data, queued idle, or queued
break character finishes transmitting before allowing the pin to revert to a general-purpose I/O pin.
Table 15-3. SCIxC1 Field Descriptions (continued)
Field Description