Filter
Top Products
Call Answer Service
Repeat Steps 4 and 5 for each VMS-Mail line for which an extension number is
written in the VMS-Mail column.
Automatic VMS Cover
Check communications system Planning Form B2 to see if Automatic VMS Cover is
assigned to any extensions. If it is, follow the procedure below. If not, skip to “VMS
Cover Rings.”
To change the Automatic VMS Cover setting for an extension to Assigned as
indicated on Form B2:
6.
1.
2.
3.
4.
5.
6.
1.
2.
Press [
#
] [
3
] [
1
] [
0
].
Enter the number of the first extension to which Automatic VMS Cover is to be
assigned.
Press [
Next Data
] until the display reads
1 Assigned.
To program another extension, press [
Next Item
] or [
Prev Item
] until the extension
number shows on the display.
Press [
Next Data
] until the display reads
1 Assigned.
Repeat Steps 4 and 5 for each extension to which Automatic VMS Cover is to be
assigned.
VMS Cover Rings (Communications System Release
4.0 or later)
Check communications system Planning Form A, Page 2, to see if VMS Cover Rings
(#117) is different from the factory setting of 3. If it is, follow the procedure below. If
not, skip to “Exiting Programming Mode.”
To change the number of times calls ring before they are sent to the mail system as
indicated on Form A, Page 2, VMS Cover Rings:
Press [
#
] [
1
] [
1
] [
7
].
Enter the VMS Cover Rings setting.
Exiting Programming Mode
To exit programming mode, press [
Feature
] [
0
] [
0
].
Communications System Initial Programming
4-9