Filter
Top Products
Before You Begin
Preparing the Communications System
You must program a few communications system features before you program
the mail system. The following instructions assume that you are familiar with
communications system programming. If you are not, refer to the Programming
and Use guide for the communications system.
For these procedures, you need communications system Planning Forms B1
and B2 to identify the extension numbers associated with the mail system unit
and the Remote Maintenance Device.
Hunt Group Extensions
Use this procedure to assign the extensions associated with the mail system
unit to Hunt Group 7, the VMS Hunt Group.
1.
2.
3.
4.
5.
6.
7.
8.
9.
At extension 10 or 11, press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
].
Press [
#
] [
5
] [
0
] [
5
].
At the Group:
prompt, press [
7 ].
At the Extension: prompt, enter the first PARTNER MAIL extension
number specified on communications system Planning Form B1.
NOTE:
The first extension jack on 206 modules should not be used as a
PARTNER MAIL extension. These jacks should be reserved for use
during a power failure.
Press [
Next Data
] until the display reads
1 Assigned.
Press [
Next Item
] or [
Prev Item
] until the next PARTNER MAIL extension number
displays.
Press [
Next Data
] until the display reads
1 Assigned.
If additional PARTNER MAIL extensions are specified on Form B1, repeat
Steps 6 and 7 for each one.
If this is a PARTNER II system in Hybrid mode, continue with “Line Access
Mode” on page 3-3. Otherwise, go to “Transfer Return Extension” on
page 3-3.
3-2
Mail System Initial Programming