Filter
Top Products
The exclamation point in an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the
literature accompanying the product.
IMPORTANT SAFETY INSTRUCTIONS
When installing telephone equipment, always follow basic safety precautions to reduce
the risk of fire, electrical shock, and injury to persons, including:
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
Read and understand all instructions. (Pay particular attention to
Communications System Hardware on page 2-2 and Mail System Site
Requirements on page 2-3.)
Follow all warnings and instructions marked on or packed with the product.
Never install this unit or telephone wiring for it during a lightning storm.
Never install a telephone jack in a wet location unless the jack is specifically
designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone
wiring has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Use only PARTNER modules in the PARTNER communications system control
unit.
Use only recommended/approved PARTNER communications system
accessories.
Do not install this product near water, for example, in a wet basement location.
Do not overload wall outlets, as this can result in the risk of fire or electrical
shock.
The mail system is equipped with a three-wire grounding-type plug with a third
(grounding) pin. This plug will fit only into a grounding-type power outlet. This is
a safety feature. If you are unable to insert the plug into the outlet, contact an
electrician to replace the obsolete outlet. Do not defeat the safety purpose of the
grounding plug.
Do not attach the power supply cord to building surfaces. Do not allow anything
to rest on the power cord. Do not locate this product where the cord will be
abused by persons walking on it.
Vents on the sides of the cabinet are provided for ventilation. To protect this
equipment from overheating, do not block these openings.
Never push objects of any kind into this product through vent openings in the
unit, as they may touch dangerous voltage points or may short out parts, which
could result in a risk of fire or electrical shock. Never spill liquid of any kind on
this product.
If there is not sufficient room on the existing wood mounting surface, either
secure a new surface (a piece of plywood) or use wall studs to install the mail
system unit. This ensures permanent mounting and prevents wall damage.
Unplug the product from the wall outlet before cleaning. Dust with a soft cloth.
Do not use cleaners or aerosol cleaners.
Do not operate the system if chemical gas leakage is suspected in the area. Use
telephones located in some other safe area to report the trouble.
WARNING:
DO NOT open the mail system unit. There are no user-serviceable parts inside the
unit Only an authorized technician should open the unit for required maintenance
or upgrading purposes.
SAVE THESE INSTRUCTIONS
2-ii
Installation