Filter
Top Products
Communications System
Initial Programming
Introduction
This chapter contains procedures for communications system features that must be
programmed for proper operation of the mail system. This information assumes that
communications system forms have been completed and that you are familiar with
communications system programming.
For information about communications system forms, refer to Appendix B. For
information about communications system programming and features, refer to the
Programming and Use guide for the communications system.
References to forms throughout this chapter are based on communications system
Release 4.1 forms. The terminology and page numbers may vary slightly on forms for
other releases of the communications system.
The procedures in this chapter assume that this is the first time a mail system is
being installed on an existing communications system. If this is not the case, some of
the communications system’s settings may already be changed to the values
specified here. It is recommended that you perform each procedure and verify all of
the settings.
Before You Begin
Before you begin, locate communications system Planning Forms A, B1, B2, C and
D.
Communications System Initial Programming
4-1