Filter
Top Products
Logging In to System Administration
2.
3.
4.
At the
Extension:
prompt, enter the extension number where the Remote
Maintenance Device (VMS-RMD) is installed as specified on
communications system Planning Form B1.
Press [
Remove
] to remove all existing line assignments.
Continue with “Automatic Extension Privacy.”
Automatic Extension Privacy for the
Remote Maintenance Device
Use this procedure to assign Automatic Extension Privacy to the extension to
which the Remove Maintenance Device is connected so that users cannot
interrupt transmission.
1.
2.
3.
4.
Press [
#
] [
3
] [
0
] [
4
].
At the Extension:
prompt, enter the extension number where the Remote
Maintenance Device (VMS-RMD) is installed as specified on
communications system Planning Form B1.
Press [
Next Data
] until the display reads
1 Assigned.
Press [
Feature
] [
0
] [
0
] to exit programming.
Logging In to System Administration
To program the mail system, you will log in to the System Administrator’s
mailbox and access the System Administration Menu.
For initial programming, you will use the factory setting for the System
Administrator’s mailbox. The System Administrator’s mailbox password and the
Administration password are not factory-set, so you will be prompted to set
them. Be sure the System Administrator knows the passwords that you choose,
because the System Administrator will need them in the future to log in.
Security Alert:
It is strongly recommended that the System Administrator change the
System Administrator’s mailbox password and the System Administration
Password after initial programming is complete. Instructions are provided
at the end of this chapter.
1.
Press [
Intercom
] [
7
] [
7
] [
7
].
The Voice Mail Greeting plays, followed by the extension prompt.
Mail System Initial Programming
3-5