Filter
Top Products
RL78/G1A CHAPTER 12 SERIAL ARRAY UNIT
R01UH0305EJ0200 Rev.2.00 452
Jul 04, 2013
Figure 12-35. Procedure for Resuming Master Reception
Starting setting for resumption
Port manipulation
Changing setting of the SPSm register
Changing setting of the SDRmn register
Changing setting of the SMRmn register
Changing setting of the SOm register
Port manipulation
Writing to the SSm register
Completing resumption
Disable clock output of the target
channel by setting a port register and a
port mode register.
Re-set the register to change the operation
clock setting.
Re-set the register to change the transfer
baud rate setting (setting the transfer
clock by dividing the operation clock
(f
MCK
)).
Re-set the register to change serial mode
register mn (SMRmn) setting.
Set the initial output level of the serial
clock (CKOmn).
Enable clock output of the target channel
by setting a port register and a port mode
register.
Set the SSmn bit of the target channel to 1
(SEmn bit = 1: to enable operation).
Setting is completed
Sets dummy data to the SIOp register (bits 7
to 0 of the SDRmn register) and start
communication.
(Essential)
(Selective)
(Selective)
(Selective)
(Selective)
(Essential)
(Essential)
Re-set the register to change serial
communication operation setting register
mn (SCRmn) setting.
(Selective)
Changing setting of the SCRmn register
If the OVF flag remain set, clear this
using serial flag clear trigger register mn
(SIRmn).
(Selective)
Clearing error flag
Completing master
p
re
p
arations?
(Essential)
Ye s
No
Wait until stop the communication target
(slave) or communication operation
completed
Remarks 1. If PER0 is rewritten while stopping the master transmission and the clock supply is stopped, wait
until the transmission target (slave) stops or transmission finishes, and then perform initialization
instead of restarting the transmission.
2. m: Unit number (m = 0, 1), n: Channel number (n = 0 to 3),
p: CSI number (p = 00, 01, 10, 11, 20, 21), mn = 00 to 03, 10, 11