Filter
Top Products
RL78/G1A CHAPTER 11 A/D CONVERTER
R01UH0305EJ0200 Rev.2.00 346
Jul 04, 2013
11.3.1 Peripheral enable register 0 (PER0)
This register is used to enable or disable supplying the clock to the peripheral hardware. Clock supply to a hardware
macro that is not used is stopped in order to reduce the power consumption and noise.
When the A/D converter is used, be sure to set bit 5 (ADCEN) of this register to 1.
The PER0 register can be set by a 1-bit or 8-bit memory manipulation instruction.
Reset signal generation clears this register to 00H.
Figure 11-2. Format of Peripheral Enable Register 0 (PER0)
Address: F00F0H After reset: 00H R/W
Symbol <7> 6 <5> <4> <3> <2> 1 <0>
PER0 RTCEN 0 ADCEN IICA0EN SAU1EN
Note
SAU0EN 0 TAU0EN
ADCEN Control of A/D converter input clock supply
0
Stops input clock supply.
• SFR used by the A/D converter cannot be written.
• The A/D converter is in the reset status.
1
Enables input clock supply.
• SFR used by the A/D converter can be read/written.
Note 32-, 48-, 64-pin products only
Cautions 1. When setting the A/D converter, be sure to set the following registers first while the ADCEN
bit is set to 1. If ADCEN = 0, the values of the A/D converter control registers are cleared to
their initial values and writing to them is ignored (except for port mode registers 0 to 5, 7, 12,
and 15 (PM0 to PM5, PM7, PM12, PM15), port mode control registers 0, 1, 3 to 5, 7, and 12
(PMC0, PMC1, PMC3 to PMC5, PMC7, PMC12), and A/D port configuration register (ADPC)).
• A/D converter mode register 0 (ADM0)
• A/D converter mode register 1 (ADM1)
• A/D converter mode register 2 (ADM2)
• 12-bit A/D conversion result register (ADCR)
• 8-bit A/D conversion result register (ADCRH)
• Analog input channel specification register (ADS)
• Conversion result comparison upper limit setting register (ADUL)
• Conversion result comparison lower limit setting register (ADLL)
• A/D test register (ADTES)
2. Be sure to clear the following bits to 0.
25-pin products: bits 1, 3, 6
32, 48, 64-pin products: bits 1, 6
<R>