Filter
Top Products
CHAPTER 3 NDA-24282
Page 36
Revision 1.0
INSTALLATION
4.2 BASIC DATA ASSIGNMENT FOR START-UP
STEP 1 : Change the system data written in DM.
ASYD SYS1
INDEX2 - b0=1 (ACDP mounted)
INDEX31 - b0~b3: CM mounting capacity
Assign Normally “06”.
Note 1
INDEX79 - b6=0 (ACD service is effective)
Note 1
INDEX207 - b0=1 (ACDP in system0 is used)
b1: ACDP in system1
0/1=Not used/Used
INDEX241 - b2=1 (call event process)
Note 1
Note 1:
When the ACD service is activated via FCCS, this data must be set to all nodes providing ACD service (Not
just the node accommodating the ACDP).
STEP 2 : Assign the system data written in LDM as shown below.
ASYDL SYS1
INDEX512: FPC of the self-node
INDEX513: 01 Hex (LDM usage)
INDEX515~518 b0~b7: IP address (Hex) for PBX over external LAN
Note 2
INDEX519~522 b0~b7: Subnet Mask (Hex) for PBX over external LAN
Note 2
INDEX523~526 b0~b7: Default Gateway Address for External LAN
(This data is required when the Host is connected via gateway)
Note 2
INDEX864 - b0=1 (Built-in ACDP is provided)
INDEX864 b1: Output the system message (4-R) when TCP-IP is normally disconnected.
0/1 = Effective/Ineffective
Note 3
b2: 0/1 = “Agent Anywhere” Out of Service/In Service
b3: 0/1 = Multiple ACDPs Not Available/Available
INDEX865: FPC of Node Providing IP.
INDEX866: FPC of Node Providing ACDP.
Note 2:
If the MAT or SMDR has been connected with external LAN already, this data assignment is not necessary.
STEP 3 : Assign the System data written in NDM.
This data is necessary when using “AGENT ANYWHERE” (Available since the PBX software
Series 7300.)
ASYDN SYS1
INDEX514- NDM usage
INDEX533- FPC of the node that provides VNDM
STEP 4 : Check the station-to-station connection and confirm no fault status occurs or system messages
are output (such as cable connection fault, LCD display fault, memory alarm fault, abnormal
interrupt, etc.).
STEP 5 : Program the ACD office data. Also, program the Fusion data to make ACD service effective
through Fusion network, if necessary. Refer to Chapter 5, “Office Data Design”.
STEP 6 : Save the DM, ACD data memory into the HDD by using MEM_HDD.