Filter
Top Products
NDA-24282 (E) CHAPTER 9
Page 439
Revision 1.0
SYSTEM MAINTENANCE
Fault logical channel number (LCID): 01~10H (00 means the data is invalid)
When the PBX software Series 7300 and the ACD software R2 or the later software are installed
Fault port number: 0-5
Communication Protocol: 03 = ETHER + TCP/IP
Error Code (ERR): Refer to the table below
Note 1: This error code shows that the Host (UAP) is down manually. The option not to output this detail message at some
offices can be programmed using SYS1, INDEX864, b1 in ASYDL (Messages other than ERRK = 01 are output when
TCP connection disconnected is not output).
Fault logical channel number (LCID): 01~10H (00 means the data is invalid)
~ IP address
Relation between LCID and PBX TCP port number
LCID TCP port number of the PBX
01 60030
PROTOCOL ERROR CODE CONTENT OF FAULT
03
(ETHER + TCP/IP)
01 TCP Connection disconnected (Normal)
Note 1
12 (0C) Abnormal UAP is detected by Heart Beat function
13 (0D) ~ 255 (FF) Not used
Relation between LCID and PBX TCP port number
LCID TCP port number of the PBX
01 60030
4
1
2
3
2 3
4
5 8