Filter
Top Products
CHAPTER 9 NDA-24282 (E)
Page 438
Revision 1.0
SYSTEM MAINTENANCE
3.2 MESSAGE DETAIL DATA
This section describes the detailed information on the faults indicated by system messages (message detail data).
3.2.1 MESSAGE DETAIL DATA OF SYSTEM MESSAGE “4-R”
System Message 4-R: TCP/IP Link Failure
1. Print-out Format
2. Print-out information (typical)
When the PBX software Series 7300 and the ACD software R1 or earlier software are installed
Fault port number: 0-5
Communication Protocol: 03 = ETHER + TCP/IP
Error Code (ERR): Refer to the table below
Note 1:
This error code shows that the Host (UAP) is down manually. The option not to output this detail message
at some offices can be programmed using SYS1, INDEX864, b1 in ASYDL (Messages other than ERR = 01
are output when TCP connection disconnected is not output).
Note 2:
This data is output when using PBX software Series 7300 or earlier. If installing PBX software Series 7300
or later, this information is output in the system message “26-V”.
PROTOCOL ERROR CODE
CONTENT OF FAULT
03
(ETHER + TCP/IP)
01 TCP Connection disconnected (Normal)
Note 1
02 Reception of a text which cannot be analyzed
Note 2
03~09 Not used
10 (0A) TCP Connection disconnected (on the way)
Note 2
11 (0B) Transmission to PZ-PC19 (LANI) is disabled (Permanent)
Note 2
12 (0C) Abnormal UAP is detected by Heart Beat function
13 (0D) Not used
14 (0E) TCP/IP Connection Error (B-level Infinite Loop, etc.)
15 (0F) ~ 255 (FF) Not used
TCP/IP Link
re
SYSTEM MESSAGE 4 - R TCP/IP Link Failure
NEC - ESD DEC 22 21:32
1: xx xx xx xx xx xx xx xx 2: xx xx xx xx xx xx xx xx
1 2 3
4
5 6
7
8 9
10
11 12
13
14 15 16
1
2
3
2 3