Filter
Top Products
NDA-24282 (E) CHAPTER 5
Page 185
Revision 1.0
OFFICE DATA DESIGN
Data Programming
Step 1: ASYDL - ACD for Fusion Network. This data must be set for all nodes to be provided ACD service.
SYS1, INDEX512: FPC number of the self-node (1-253)
*SYS1, INDEX865: FPC of the node providing IP. (When IVR is used, this data is necessary)
*SYS1, INDEX866: FPC of the node providing built-in ACDP.
Note 1:
The same value (FPC) must be set to these indexes.
Note 2:
Assign 0 for the node using ACD service in the self node only.
Step 2: ASYDN - SYS1, INDEX514: NDM usage
Step 3: Data programming procedures other than Steps 1, 2 are the same as those for the non-Fusion system
(ACD stand-alone system). However, note which data is necessary for the node providing ACDP. The
others are set to all Fusion nodes in which ACD trunks or ACD agents are installed.
Data required for the node that accommodates ACDP:
ASYD - SYS1, INDEX2, b0:1=ACDP is used
SYS1, INDEX207, b0:1=ACDP0 is used
SYS1, INDEX207, b1:0/1=ACDP1 is not used/used
Note 4
ASYDL - SYS1, INDEX864, b0:1=Built-in ACDP is used
Note 3:
PBX command data such as AKYD, AOKC, ASFC is set to all nodes in a Fusion Network.
Note 4:
Not used in Internal ACD.