NDA-24282 (E) CHAPTER 4
Page 153
Revision 1.0
PA-4DATB (DAT)
7. Reference
How to Record a Message
• Prior to your recording, set switches on the DAT card according to the following example.
SWITCH SETTINGS ON DAT (Example <240 sec mode>)
• Connect a tape recorder to the DAT card with a cable.
• Turn On the MBRQ key to make busy a channel to be recorded.
(To record a message in the 240 sec. mode, all circuits must be placed into MB state.)
• Turn the WR key upwards.
(The corresponding BL lamp lights green indicating the tape recorder has been connected to the cir-
cuit.)
• Turn the START key upwards.
(The corresponding BL lamp starts flashing.)
• Start the tape recorder and record your message in the designated channel.
<recording>
• The corresponding BL lamp (BL0 ~ BL7) lights steadily. (Recording ends.)
• Return the START, WR key to the previous position.
SWITCH SETTING DESCRIPTION
SW1
SW4
Timer Value for Channel 0-3: 240 sec.
SW5 Circuit Card Timer: 60 sec. A-law/µ-law: A-law External Music Source/ An-
nouncement Equipment: Announcement Equipment
SW6 Single/Repeated Playback: Repeated Playback
MRCS Channel Designation:
240 sec mode
DAT
Front
Jack
earphone jack (3.6 ø)
Tape Recorder