CHAPTER 9 NDA-24282 (E)
Page 452
Revision 1.0
SYSTEM MAINTENANCE
5.3 MIS FAULT RECOVERY PROCEDURES
This paragraph describes the fault recovery procedures related to the MIS in the order shown below.
1. MIS Restart Processing
Step 1: By selecting MIS System Stop, cause the MIS to cease operating.
Step 2: Turn off the power supply to the MIS. After 5 ~ 6 seconds, turn on the power supply again.
Step 3: The MIS starts up.
Step 4: Perform operation tests of the MIS.
2. Check on Connection Cables
Check to see if the cable is connected between the MIS and the NEAX2400 IMX.