Filter
Top Products
CHAPTER 7 NDA-24282 (E)
Page 368
Revision 1.0
AADTN: Assignment of Announcement/Dictation Trunks for NDM
AADTN: Assignment of Announcement/Dictation Trunks for NDM
1. Function
This command is used to assign, display and delete announcement trunks for delay announcements, night
announcements, etc. Also used to assign, display and delete Dictation Trunks for such purposes as
Emergency Recorder. The announcement trunk or dictation trunk programmed in AADTN is allowed to
use from the remote ACD node within Fusion Network.
2. Precautions
Before LENS of assignment trunks or night announcement is changed in ATRK, the AADTN command
data should be deleted first. In addition, if LEN data is deleted in ATRK by accident, this command data is
also deleted automatically.
3. Parameters
TYPE: 1 = ANT (Announcement Trunk)
2 = DCT (Dictation Trunk)
NO: ANT/DCT Number
Announcement = 1 ~ 58
Dictation = 1 ~ 5
D: Availability of Disconnect Timer (Available for TYPE = ANT)
0 = Disconnect timer not available
1 = Disconnect timer available (normal)
Note 1
MSGT: Message Timer (2 ~ 120 sec. 2-sec. interval when shorter than 30 sec. 8-sec. interval
when longer than 30 sec.)
CP: Connection Pattern
Note 2
0 = Multiple Connection
1 = Single Connection
WAIT: Waiting Timer (0~30sec. 2sec. interval)
Note 2
CNT: Number of Announcement/Dictation Trunks (1 ~ 8)
LGRT: LOGICAL Route Number (1 ~ 254)
TK: Trunk Number (1 ~ 255)
Note 1:
When D=1, msg disconnect timer is set at 30 seconds.
Note 2:
Not available since the DAT control function is not available in Fusion network. Always assign “0”=ASYD,
SYS1, INDEX449, b2 for the announcement to be provided in Fusion network.
Note 3:
For Fusion network, DAT control function is not available.