Filter
Top Products
CHAPTER 7 NDA-24282 (E)
Page 354
Revision 1.0
AMNO: Assignment of Monitored Number
AMNO: Assignment of Monitored Number
1. Function
AMNO is used to assign monitored numbers into the PBX database. The numbers programmed in AMNO
will also be programmed into ACDPLT (the ACD database). The monitored numbers programmed in
AMNO are the entry points for pilot numbers into the ACD system.
2. Precautions
1. When the monitored number (MNO) is deleted, delete MNO in ACDPLT prior to this command.
2. When UCD=1 is programmed in this command, UCD service should be programmed beforehand.
3. Parameters
TN: Tenant Number of Monitored Number
MNO: Monitored Number (maximum 5 digits. the number is the same as the pilot number
assigned in ACDPLT and must match the numbering plan of the NEAX2400 IMX.
NMI: Number Monitored Index (1 ~ 4095)
UCD: UCD degrade
0 – No
1 – Yes
STN: UCD Control Station Number (Available for UCD=1)
Note 1
A/G: Station type of Hotel System
Note 2
A: Administration Station
G: Guest Station
MFC: G-2 Signal Data for MFC (0-3)
Note 3
0 = ASFC, SFI 59 = 0 and SFI 60 = 0
1 = ASFC, SFI 59 = 1 and SFI 60 = 0
2 = ASFC, SFI 59 = 0 and SFI 60 = 1
3 = ASFC, SFI 59 = 1 and SFI 60 = 1
Note:
Each monitored number must be assigned to different Monitored Number Index.
“0”cannot be assigned at the first digit of the monitored number.
Note 1:
When a C.O. trunk is used for UCD control station, UCD controlling station number should be
programmed in ACSI in advance.
Note 2:
For Business System, “A (Administration Station)” is assigned here.
Note 3:
Valid for countries except Australia and North America.