Filter
Top Products
CHAPTER 4 NDA-24282 (E)
Page 168
Revision 1.0
PA-CC98 (ETHER)
SW1 (Continued)
4
ON Sets 0, corresponding to bit 11 of MAC address
OFF Sets 1, corresponding to bit 11 of MAC address
5ON× Fixed
6ON× Fixed
7ON× Fixed
8ON× Fixed
[Reference]
Setting of MAC address
On LAN and TCP/IP, this circuit card can have the following
addresses and ports.
MAC Address: 000032250xxxH (48 bits)
TCP Port Numbers: 16 port numbers of 1024 ~ 1039
The last 12 bits of MAC address must be set by switches
SW0 and SW1 before starting up this circuit card.
(Ex.)
When MAC address is to be set to 000032250123H:
By dividing 12 bits into 4-bit units (refer to the table on the
right side), and set the switches as shown below.
SW2
(Rotary SW)
0
Fixed setting (When operating)
SWITCH
DIP SW
No.
SETTING
DEFAULT
SETTING
MEANING
0H
1H
2H
3H
4H
5H
6H
7H
8H
9H
AH
BH
CH
DH
EH
FH
Relation between the value
of 4 Bits and Switch Setting
Hex Switch Setting
0 = Fixed (not used)
SW0
SW1
1 2 3 4 5 6 7 8
ON
32
1 2 3 4 5 6 7 8
ON
10