Filter
Top Products
NDA-24282 CHAPTER 8
Page 429
Revision 1.0
SYSTEM OPERATIONS
2.3 WORK MODE
(a) Work mode manual setting
Use the following procedure to enter Work mode when the contents of the ACD call requires it.
(b) Work mode automatic setting
Use the following procedure if it is required to activate the Work mode automatically after every ACD
call.
Press the WORK key during communication with an ACD call.
The lamp lights up and WORK PENDING is displayed.
Press the RELEASE key.
WORK MODE is displayed, indicating the Work mode.
(End of work)
Press the WORK key.
The lamp goes off and READY is displayed.
Work mode ends, and the position becomes available for receiving the next ACD call.
Press the RELEASE key during communication with an ACD call.
An incoming ACD call is completed.
WORK MODE is displayed, indicating the Work mode.
(End of work)
Press the WORK key.
The lamp goes off and READY is displayed.
Work mode ends, and the position becomes available for receiving the next ACD call.
START
END
START
END