Filter
Top Products
CHAPTER 7 NDA-24282
Page 348
Revision 1.0
AKYD: ASSIGNMENT OF KEY DATA FOR D
TERM
AKYD: Assignment of Key Data for D
term
1. Function
This command is used to assign, delete, and display the following key data corresponding to each line/
feature buttons of D
term
. For details of this command, refer to “AKYD” command in NEAX2400 IMX
Office Data Specification.
•Line Key Data
• Function Key Data
2. Precautions
1. Before assigning the key data for D
term
by this command, be sure to assign the station data (TN, STN,
TEC = 12 (D
term
)) of the D
term
by ASDT command. The station number assigned by ASDT command
is referred to as “My Line”.
Note:
The “My Line” corresponds to the physical port associated with the LENS of a DLC/ELC card.
2. By assigning another station line to a function button by this command, an incoming call terminated to
a station line other than My Line can be answered or can be transferred to elsewhere as in the case of
the My Line. A station line other than My Line is referred to as a “Sub Line”. A “Sub Line” can be
assigned not only to a D
term
but to any conventional telephone. In addition, the station data for My Line
and Sub Line must be assigned via the ASDT command before the key data is assigned. When the Sub
Line and the My Line belong to different tenants, use the ATNR command and clear the “Tenant to
Tenant Restriction”.
3. A Multi-Line key (the key for My Line and Sub Line) on the D
term
can be assigned as “Prime Line”. If
the Prime Line is not assigned, the My Line will serves as the Prime Line. When the user goes off-hook,
the Prime Line is automatically connected to the D
term
.
4. A virtual line can be assigned as a Sub Line of the D
term
. The virtual line can be used the same way as
the My Line for outgoing calls and other service operations.
Note:
Virtual Line — A virtual LENS exists only in memory, but does not exist physically. Data can be assigned
but no hardware is provided for it; ex. LENS = 000311. The virtual LENS is assigned station data using the
ASDT command in the same way as for on ordinary line. (The telephone class is TEC = 18: Virtual Line)
5. When this command is used, the DLC/ELC card must be reinitialized (MB switch UP-DOWN).
6. Key data programmed in this command must be set to all nodes to be provided ACD service for Fusion
network.
Note:
Use Command ADKS for Series E D
term
.