Filter
Top Products
NDA-24282 CHAPTER 7
Page 335
Revision 1.0
ASYD: ASSIGNMENT OF SYSTEM DATA
System Data-1 Programming Sheet
Note:
This Data Programming Sheet is only for the data to be set in the ACD System. Be sure to use this Data
Programming Sheet together with the Data Programming Sheet for “ASYD” command described in the
NEAX2400 IMX Office Data Specification.
Note 1:
For ACD system to be activated through Fusion network, this data is programmed in the node providing
ACDP only. Other system data than INDEX2 must be set to all nodes to be provided ACD trunk-Fusion
within Fusion network.
Note 2:
When changing this index from 02 (normal setting for non- OAI/ACD system) to 04, you must back up DM
to the HDD of the system.
Note 3:
Valid since the PBX software Series 7300 and the ACD software R1.
SYSTEM
DATA
TYPE
(SYS)
SYSTEM
DATA
INDEX
(INDEX)
0 ~ 511
DATA
(DATA)
00 ~ FF
(Hex)
BIT
CORRESPONDING
DATA
SYSTEM DATA CONTENTS
DATA
0/1
BIT
1
201 1 b
0
1=ACDP is used
(Assign 01 Hex)
Note 1
27 0 b
4
ACD in Service (Fixed Data)
0 = In service; 1 = Out of service
31 04 1 b
2
Note 2
42 b
2
System Message “5-Q” is output.
0/1 = No/Yes
Note 3
47
b
0
Traffic Measurement Indication
0/1 = CCS Indication/Erlang Indication
1b
1
b
2
b
1
TCFI timer: 0 0 = 2 sec. interval
Note 4
1 1 = Application Dependent
(Standard)
0 1 = 4 sec. interval
1 0 = 8 sec. interval
1b
2
0b
3
0 = Display last number for TCFD
1 = Display message
Note 5
b
4
ACD Busy Tone Control
0/1 = No/Yes
Note 6
b
7
Traffic Measurement for Terminal and Route Traffic
0/1 = Out/In Service