Filter
Top Products
Administrator Level Options
41-001343-02 REV04 – 05.2014 3-8
Configuration File Options
An Administrator can enter specific parameters in the configuration files to configure the IP phones. All parameters in con-
figuration files can only be set by an administrator.
References
For a procedure on using the configuration files, see Chapter 2, the section, “Configuration Files (Administrator Only)” on
page2-1.
For a description of each parameter you can enter in the configuration files, see AppendixA, “Configuration Parameters.”
Phone Status
The Phone Status on the IP Phone displays the network status and firmware version of the IP phone.
You can display phone status using the IP phone UI or the Aastra Web UI.
Phone Status via IP Phone UI
In the IP phone UI, the Phone Status options are available to the user and the administrator and do not require a password
entry.
Phone Status All IP Phones Except the 6739i and 6867i
• IP&MAC Addresses
– Displays the IP address and MAC address of the phone.
• LAN Port
– Displays the Link State, Negotiation Method, Speed, and Duplex Method that the phone uses on its LAN port.
• PC Port
– Displays the Link State, Negotiation Method, Speed, and Duplex Method that the phone uses on its PC Port.
• Firmware Info
– Displays information about the firmware and boot version that is currently installed on the IP phone.
• Error Messages
– Displays any error messages that occurred during the phone’s last reboot.
Phone Status for 6739i IP Phone
• Firmware
– Displays information about the firmware and boot version that is currently installed on the IP phone.
• Network
– IP&MAC Addresses
– Displays the IP address and MAC address of the phone.
– LAN Port
– Displays the Link State, Negotiation Method, Speed, and Duplex Method that the phone uses on its LAN port.
– PC Port
– Displays the Link State, Negotiation Method, Speed, and Duplex Method that the phone uses on its PC Port.
• Error Msg
– Displays any error messages that occurred during the phone’s last reboot.