Filter
Top Products
Operational Features
5-32 41-001343-02 REV04 – 05.2014
Switching the 6867i IP Phone’s Home/Idle Screen Mode
Use the following procedures to switch the 6867i IP phones home/idle screen mode.
Picture ID Feature
The Picture ID feature on the 6739i and 6867i shows a picture ID of a caller on the LCD for all of the following events on
the phone:
• Incoming Calls (matched to Caller ID numbers)
• Outgoing Calls (matched to dialed numbers)
• Directory entries
• Callers List entries
• Redial List entries
Your Administrator stores the pictures in a centralized picture repository. The pictures are dynamically retrieved from the
centralized server for each call and then locally cached in the phone to reduce network traffic.
If there is no picture on the central server for the dialed number and/or Caller Id number, and Directory, Callers List,
and/or Redial List entry, the generic blue figure image is shown.
Pictures must be in “.png” format, 150pixels wide x 200pixels tall, and in 24-bit color (the 6867i also supports 32-bit
color). The filenames for pictures must be stored using the phone number as the filename (for example,
9995551234.png). Enabling and disabling Picture ID on the phone can be done by an Administrator using the configura-
tion files only
Enabling/Disabling the Picture ID on the Phone Using the Configuration Files
Use the following parameter to enable/disable Picture ID on the phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Configurable Home/Idle Screen Modes” on pageA-55.
Note:
Applicable to the 6739i and 6867i IP Phones only.
Note:
The Picture ID feature supports the use of TFTP, FTP, HTTP, and HTTPS protocols when downloading pictures.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Picture ID Feature” on pageA-56.
Generic
Blue Image