Aastra Telecom 41-001343-02 IP Phone User Manual


  Open as PDF
of 876
 
Administrator Level Options
41-001343-02 REV04 – 05.2014 3-18
Call Waiting Tone Period
Note:
This option can be set by an
Administrator only.
call waiting tone period Specifies the time period, in seconds, that the call waiting tone is audible on an active
call when another call comes in. When enabled, the call waiting tone plays at regular
intervals for the amount of time set for this parameter. For example, if set to “30” the
call waiting tone plays every 30 seconds. When set to “0”, the call waiting tone is audi-
ble only once on the active call.
For more information on this feature, see “Call Waiting Tone Period” on page5-59.
Preferred Line
Note:
This option can be set by both
Users and Administrators.
preferred line Specifies the preferred line to switch focus back to when incoming or outgoing calls
end on the phone.
For more information on this feature, see “Preferred Line and Preferred Line Timeout”
on page5-68.
Preferred Line Timeout (sec-
onds)
Note:
This option can be set by both
Users and Administrators.
preferred line timeout Specifies the time, in seconds, that the phone switches back to the preferred line
after a call (incoming or outgoing) ends on the phone, or after a duration of inactivity
on an active line.
For more information on this feature, see “Preferred Line and Preferred Line Timeout”
on page5-68.
Goodbye Key Cancels Incom-
ing Call
Note:
This option can be set by both
Users and Administrators.
goodbye key cancels incoming
call
Enable or disables the behavior of the Goodbye Key on the IP phone.
For more information on this feature, see “Goodbye Key Cancels Incoming Call” on
page5-69.
Message Waiting Indicator
Line
Note:
This option can be set by both
Users and Administrators.
mwi led line Allows you to enable the Message Waiting Indicator (MWI) on a single line or on all
lines on the phone. For example, if you set this parameter to 3, the LED illuminates if
a voicemail is pending on line 3. If you set this parameter to 0, the LED illuminates if
a voicemail is pending on any line on the phone (lines 1 through 9).
For more information on this feature, see “Message Waiting Indicator Line” on
page5-71.
DND Key Mode
Note:
This option can be set by both
Users and Administrators.
dnd key mode Allows you to configure the DND mode to use on the phone (Account, Phone, Cus-
tom) when the DND key is pressed. You can configure DND for all accounts or a spe-
cific account.
For more information on this feature, see “DND Key Mode” on page5-73. Also see
Chapter 5, the section, “Do Not Disturb (DND)” on page5-154.
Call Forward Key Mode
Note:
This option can be set by both
Users and Administrators.
call forward key mode Allows you to configure the Call Forward mode to use on the phone (Account, Phone,
or Custom). You can configure Call Forward
for all accounts or a specific account.
For more information on this feature, see “Call Forward Mode” on page5-75. Also see
Chapter 5, the section, “Call Forwarding” on page5-190.
N/A use lldp elin Enables or disables the use of an Emergency Location Identification Number (ELIN)
received from LLDP as a caller ID for emergency numbers.
Caution:
In Release 2.3 and later, LLDP is enabled by default. If LLDP is enabled on your net-
work, the phones may come up with different network settings.
For more information on this feature, see “Link Layer Discovery Protocol for Media
Endpoint Devices (LLDP-MED) and Emergency Location Identification Number
(ELIN)” on page5-77.
Parameter in
Aastra Web UI
Parameter in Configuration
Files
Description
 previous next