Filter
Top Products
Softkey/Programmable Key/Keypad Key/Feature Key/Expansion Module Key/Hard Key Parameters
41-001343-02 REV04 – 05.2014 A-202
Parameter–
hardkeyN ring splash
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description (6867i only) When a key is configured for BLF functionality, this parameter controls the
ring splash alert pattern per key. The following alerting patterns are available:
• Silence (ring splash off).
• Normal splash (same as current BLF ring splash).
• Normal - delayed (After a delay of (x) seconds, the normal ring splash is played).
• Periodic (similar to the normal ring signal that is used by the phone itself. The actual ring
melody is based on the current melody set for the line where the BLF key is associated
to).
• Periodic - delayed (after a delay of (x) seconds, the ring signal that is used by the phone
is played - see above).
• One low volume splash (same as the current BLF ring splash but at a lower level to be
less intrusive).
• One low volume splash - delayed (after a delay of (x) seconds, the ring signal that is the
same as the current BLF ring splash is played at a lower level).
When a key is configured for BLF/List functionality, this parameter controls the ring tone
per key. The following ring tones are available:
• Ring tone 1
• Ring tone 2
• Ring tone 3
• Ring tone 4
• Ring tone 5
• Silence (ring tone off)
Note:
Ring tones are based on the current ring tone set configured on the IP phone.
Format Integer
Default Value For BLF For BLF/List
0 (Silence) 105 (Silence)
Range For BLF For BLF/List
0-6 100 (Ring tone 1)
0 (Silence) 101 (Ring tone 2)
1 (Normal) 102 (Ring tone 3)
2 (Normal delayed) 103 (Ring tone 4)
3 (Periodic) 104 (Ring tone 5)
4 (Periodic delayed) 105 (Silence)
5 (Low volume)
6 (Low volume delayed)
Example For BLF:
hardkey1 ring splash: 1
For BLF/List:
hardkey1 ring splash: 101