Filter
Top Products
Operational Features
41-001343-02 REV04 – 05.2014 5-81
Configuring Intercom Calls Settings
You can configure the Intercom feature using the configuration files or the Aastra Web UI.
Use the following procedures to configure Intercom calls on the IP phone.
Note:
To configure incoming intercom calls using these parameters, see “Configuring Intercom Calls Settings” on page5-81.
Note:
An administrator can configure the incoming and outgoing Intercom feature. A user can configure the incoming Inter-
com feature only.
Configuration Files
For specific parameters you can set in the configuration files for outgoing Intercom, see Appendix A, the section, “Outgoing Intercom Settings” on
pageA-144.
For specific parameters you can set in the configuration files for incoming Intercom, see Appendix A, the section, “Incoming Intercom Settings” on
pageA-145.
Aastra Web UI
Outgoing intercom Settings
1. Click on Basic Settings->Preferences->Outgoing Intercom Settings.
2. Select an Intercom type for outgoing Intercom calls from the Type list box.
Valid values are Phone-Side, Server-Side, Off. Default is Off.
3. If Server-Side is selected, enter a prefix to add to the phone number in the "Prefix Code" field.
Note:
For Sylantro servers, enter *96.
4. If Phone-Side or Server-Side is selected, select a line from the Line list box for which you want the IP phone to use as its configuration on the
Intercom call.
Note:
The IP phone uses the configuration from the line you select from this list box. The call itself is made using the first available line at the time
of the call.
5. Click Save Settings to save your changes.