Filter
Top Products
Operational Features
41-001343-02 REV04 – 05.2014 5-137
Applicable values for the above parameters include:
• 100 (Ring tone 1)
• 101 (Ring tone 2)
• 102 (Ring tone 3)
• 103 (Ring tone 4)
• 104 (Ring tone 5)
• 105 (Silence)
Examples
To enable ring tone 3 playback for a BLF/List-monitored extension configured on a soft/prg/topsoft/expmodX “key1”, add
the following parameters in the respective configuration file:
For Softkeys
play a ring splash: 1
softkey1 type: list
softkey1 ring splash: 102
For Programmable Keys
play a ring splash: 1
prgkey1 type: list
prgkey1 ring splash: 102
For Top Softkeys
play a ring splash: 1
topsoftkey1 type: list
topsoftkey1 ring splash: 102
For Expansion Module Keys
play a ring splash: 1
expmod1 key1 type: list
expmod1 key1 ring splash: 102
Considerations
When using this feature the following must be taken into consideration:
• If there is an incoming call on a BLF/List-monitored extension, the corresponding ring tone will play only if all of the reg-
ular lines are in an idle or hold state and both paging and conf/xfer is not active.
• The BLF/List-related ring tone will stop playing if a regular line starts dialing, starts ringing, is unheld, or if paging is acti-
vated. The BLF/List-related ring tone will resume when the phone is in an idle state and paging is not active.
• If multiple BLF/List-monitored extensions are ringing simultaneously, they are placed in a queue based on the ringing
start time and priority is given to the extension that rang first. For example, if BLF/List is configured for extension 1,
extension 2, and extension 3, and all three receive incoming calls in sequence, the phone will play the ring tone for
extension 1. If ringing stops for extension1, ringing will begin for extension 2, and so on.
• Call waiting tone playback behavior for BLF/List-monitored extensions is based on the same rules as regular lines, but
the call waiting tone for BLF/List-monitored extensions will also be played/stopped when paging is activated/deacti-
vated.
Note:
Ring tones are based on the current ring tone set configured on the IP phone.