Filter
Top Products
Global SIP Settings
4-66 41-001343-02 REV04 – 05.2014
For the 6739i:
10. Enter an IP address or fully qualified host name in the Registrar Server field. Default is 0.0.0.0.
A global value of 0.0.0.0 disables registration. However, the phone is still active and you can dial using username@ip address of the phone.
If the Registrar IP address is set to 0.0.0.0 for a per-line basis (i.e., line 1, line 2, etc.), then the register request is not sent, the "No Service" mes-
sage does not display, and the message waiting indicator (MWI) does not come on.
11. Enter a Registrar Port number in the Registrar Port field for accessing the SIP registrar server.
Default is 0.
12. Press Done to save the changes.
Enabling/Disabling the Use of the Registrar Server
13. Select SIP Register.
14. Press Change to set Register to "Ye s " (enable) or "No" (disable). Default is “Ye s ”.
This parameter enables/disables the IP phone to register on the network.
15. Press Done to save the changes.
Note:
The session prompts you to restart the IP phone to apply the configuration settings.
16. Select Restart.
Note:
You can set global configuration only using the IP Phone UI.
IP Phone UI
1. Press the Options key on the phone to enter the Options List.
2. Press the Advanced button. A keyboard displays.
3. Enter the Administrator password using the keyboard. Default is “22222”.
4. Press the SIP button.
Configuring Proxy IP and Proxy Port
5. Press Proxy Server and enter an IP address or fully qualified host name in the Proxy Server field. Default is 0.0.0.0.
6. Press Proxy Port and enter a Proxy Port number in the Proxy Port field for accessing the SIP proxy server. For example, 5060. Default is 0.
Configuring Registrar IP and Registrar Port
7. Press Registrar Server and enter an IP address or fully qualified host name in the Registrar Server field. Default is 0.0.0.0.
A global value of 0.0.0.0 disables registration. However, the phone is still active and you can dial using username@ip address of the phone.
If the Registrar IP address is set to 0.0.0.0 for a per-line basis (i.e, line 1, line 2, etc.), then the register request is not sent, the "No Service" mes-
sage does not display, and the message waiting indicator (MWI) does not come on.
8. Press Registrar Port and enter a Registrar Port number in the Registrar Port field for accessing the SIP registrar server. For example, 5060.
Default is 0.
9.
Press until the Options List screen displays.
10. Press Restart to restart the phone for the change to take affect.
IP Phone UI