Filter
Top Products
Softkey/Programmable Key/Keypad Key/Feature Key/Expansion Module Key/Hard Key Parameters
41-001343-02 REV04 – 05.2014 A-194
Parameter–
prgkeyN ring splash
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description When a key is configured for BLF functionality, this parameter controls the ring splash
alert pattern per key. The following alerting patterns are available:
• 0: Silence (ring splash off).
• 1: Normal (same as current BLF ring splash).
• 2: Normal delayed (After a delay of [x] seconds, the ring signal that is the same as the
current BLF ring splash is played [use the “ring splash delay” parameter to define
the delay]).
• 3: Periodic (similar to the normal ring signal that is used by the phone itself. The
actual ring melody is based on the current melody set for the line to which the BLF
key is associated [use the “ring splash frequency” parameter to define the fre-
quency interval).
• 4: Periodic delayed (same as Periodic but after a delay of [x] seconds, the ring signal
that is used by the phone is played [use the “ring splash frequency” parameter to
define the frequency interval and the “ring splash delay” parameter to define the
delay]).
• 5: Low volume (same as the current BLF ring splash but at a lower level to be less
intrusive).
• 6: Low volume delayed (after a delay of [x] seconds, the ring signal that is the same
as the current BLF ring splash is played at a lower level [use the “ring splash delay”
parameter to define the delay]).
• 7: The behavior is determined by the global parameter “play a ring splash”.
– If “play a ring splash” is defined as 0 then the feature is disabled.
– If “play a ring splash” is defined as 1 then the behavior is the same as Normal.
– If “play a ring splash” is defined as 2 then the behavior is the same as Normal but
the ring splash plays when idle and also during the active call state.
• 8: In call delayed (same as Normal delayed but ring splash plays when idle and also
during the active call state [use the “ring splash delay” parameter to define the
delay]).
• 9: In call periodic (same as Periodic but ring splash plays when idle and also during
the active call state [use the “ring splash frequency” parameter to define the fre-
quency interval).
• 10: In call periodic delayed (same as Periodic delayed but ring splash plays when idle
and also during the active call state [use the “ring splash frequency” parameter
to define the frequency interval and the “ring splash delay” parameter to define
the delay]).
• 11: In call low volume (same as Low volume but ring splash plays when idle and also
during the active call state).
• 12: In call low volume delayed (same as Low volume delayed but ring splash plays
when idle and also during the active call state [use the “ring splash delay” param-
eter to define the delay]).
Notes:
• Ring tones are based on the current ring tone set configured on the IP phone.
• BLF alerting patterns 7 - 11 are applicable to the 6739i, 6755i, 6757i, and 6757i CT IP
phones only.
When a key is configured for BLF/List functionality, this parameter controls the ring
tone per key. The following ring tones are available:
• Ring tone 1
• Ring tone 2
•
Ring tone 3
• R
ing tone 4
• Ring tone 5
• Silence (ring tone off)
Note:
Ring tones are based on the current ring tone set configured on the IP phone.
Format Integer
Default value For BLF For BLF/List
0 (Silence) 100 (Ring tone 1)