Filter
Top Products
Advanced Operational Features
6-46 41-001343-02 REV04 – 05.2014
colon (i.e. “#61;*61” or “#61;#71” respectively).
Irrespective of a defined or undefined key value, when the Filter softkey is pressed, Executive Call Filtering will be acti-
vated and the softkey’s corresponding LED will be lit. When the Filter softkey is pressed again, Executive Call Filtering will
deactivate and the softkey’s corresponding LED will turn off.
Configuring the Filter Softkey on the Executive’s Phone Using the Aastra Web UI
Use the following procedure to configure the
Filter Softkey on the Executive’s phone
using the Aastra Web UI:
Configuring the Filter Softkey on the Executive’s Phone Using the Configuration Files
To configure the Filter softkey on the Executive’s phone using the configuration files, you must enter “filter” for the key
type. For the label (8 and 11-line phones only), enter a key label to assign to the Filter key (e.g. “Filter”). Defining the value
is optional. If you prefer to toggle Executive Call Filtering using an FAC call, enter in the Executive Call Filtering Activation
FAC (e.g. “#61”) or both the Executive Call Filtering Activation and Deactivation FACs followed by a semi-colon (e.g.
“#61;*61”) for the value. For the line setting, enter the line number for which you want to use the key functionality.
The following parameters are examples you can use to configure the Filter softkey on the Executive’s phone:
For Softkeys
softkey1 type: filter
softkey1 label: Filter
softkey1 value: “#61;*61”
softkey1 line: 1
Notes:
• If the Deactivation FAC is not specified after the semi-colon (e.g. “#61;”), the phone will ignore the semi-colon and
behave as if only the Activation FAC was defined (i.e. the phone will automatically assume that the Deactivation FAC
is in the same format but sequentially one number above the Activation FAC.
• The IP phones support Executive Call Filtering Activation/Deactivation FACs that contain the prefix “#” or “*”.
Note:
Upon a reboot, the initial state of the Filter softkey LED will correspond to the Executive Call Filtering state configured
on the call manager.
Aastra Web UI
1. Click on Operation->Softkeys and XML.
or
Click on Operation-> Programmable Keys.
or
Click on Operation->Expansion Module Keys.
2. Select a key that you want to use as a Filter activate/deactivate key.
3. In the "Type" field, select "Filter".
4. In the "Label" field (8 and 11-line phones only), enter a label to apply to this key (e.g. Filter).
5. (Optional) In the "Value" field, enter the Executive Call Filtering Activation FAC (e.g. #61) or both the Executive Call Filtering Activation and
Deactivation FACs followed by a semi-colon (e.g. #61;*61).
6. In the “Line” field, select the line for which you want to use the key functionality.
7. Click Save Settings to save your settings.