Aastra Telecom 41-001343-02 IP Phone User Manual


  Open as PDF
of 876
 
Administrator Level Options
41-001343-02 REV04 – 05.2014 3-34
Type of Service (ToS), DSCP
Advanced Network Settings include Type of Service (ToS) and Differentiated Services Code Point (DSCP) for the IP phones.
VLAN
You can enable or disable VLAN and set specific VLAN IDs and priorities under Network Settings.
Parameter In
IP Phone UI
Parameter in
Aastra Web UI
Parameters in Configuration
Files
Description
Type of Service SIP SIP tos sip The Differentiated Services Code Point (DSCP) for SIP packets.
For more information, see Chapter 4, “Type of Service (ToS),
Quality of Service (QoS), and DiffServ QoS” on page4-41.
Type of Service RTP RTP tos rtp The Differentiated Services Code Point (DSCP) for RTP packets.
For more information, see Chapter 4, “Type of Service (ToS),
Quality of Service (QoS), and DiffServ QoS” on page4-41.
Type of Service RTCP RTCP tos rtcp The Differentiated Services Code Point (DSCP) for RTCP pack-
ets.
For more information, see Chapter 4, “Type of Service (ToS),
Quality of Service (QoS), and DiffServ QoS” on page4-41.
Parameter In
IP Phone UI
Parameter in
Aastra Web UI
Parameters in Configuration
Files
Description
Global Settings
VLAN Enable VLAN Enable tagging enabled Enables or disables VLAN on the IP phones.
For more information, see Chapter 4, “Virtual LAN (optional)”
on page4-41.
Other Priority Priority, Non-IP Packet priority non-ip Specifies the priority value for non-IP packets.
For more information, see Chapter 4, “Virtual LAN (optional)”
on page4-41.
N/A HPQ Enable vlan hpq Enables or disables VLAN High Priority Queue (HPQ) on the IP
phones.
For more information, see Chapter 4, “Virtual LAN (optional)”
on page4-41.
LAN Port Settings (Port 0)
Phone VLAN ID VLAN ID vlan id Allows you to configure a VLAN ID that associates with the
physical Ethernet Port 0 (LAN port).
For more information, see Chapter 4, “Virtual LAN (optional)”
on page4-41.
SIP Priority
RTP Priority
RTCP Priority
SIP Priority
RTP Priority
RTCP Priority
tos priority map This parameter is based on the Type of Service (ToS), Differen-
tiated Services Code Point (DSCP) setting for SIP (tos sip param-
eter), RTP (tos rtp parameter) and RTCP (tos rtcp parameter). It
is the mapping between the DSCP value and the VLAN priority
value for SIP, RTP, and RTCP packets.
You enter the tos priority map value as follows:
(DSCP_1,Priority_1)(DSCP_2,Priority_2).....(DSCP_64,Priority_6
4)
where the DSCP value range is 0-63 and the priority range is 0-
7. Mappings not enclosed in parentheses and separated with a
comma, or with values outside the ranges, are ignored.
For more information, see Chapter 4, “Virtual LAN (optional)”
on page4-41.
 previous next