Filter
Top Products
Operational Features
5-262 41-001343-02 REV04 – 05.2014
When an administrator enters an XML softkey URI either via the Aastra Web UI or the configuration files, they can specify
the following variables:
• $$SIPUSERNAME$$
• $$SIPAUTHNAME$$
• $$PROXYURL$$
• $$LINESTATE$$
• $$LOCALIP$$
• $$REMOTENUMBER$$
• $$DISPLAYNAME$$
• $$SIPUSERNAME$$
• $$INCOMINGNAME$$
• $$CALLDURATION$$
• $$CALLDIRECTION$$
When the softkey is pressed, if the phone finds a URI configured with variables (in the form $$VARIABLENAME$$), they
are replaced with the value of the appropriate variable. After all of the variables are bound, the softkey executes a GET on
the URI.
Example
For example, if the administrator specifies an XML softkey with the value:
http://10.50.10.140/script.pl?name=$$SIPUSERNAME$$
This softkey executes a GET on:
http://10.50.10.140/script.pl?name=42512
assuming that the sip username of the specific line is 42512.
You can configure the XML softkey URI variables via the configuration files or the Aastra Web UI.
Configuring XML Softkey URIs
Use the following procedures to configure XML Softkey URIs using the configuration files or the Aastra Web UI.
Note:
For a description of each variable in the above list, see “Variable Descriptions” on page5-248.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,“Softkey/Programmable Key/Keypad Key/Feature
Key/Expansion Module Key/Hard Key Parameters” on pageA-156.