Filter
Top Products
Advanced Operational Features
41-001343-02 REV04 – 05.2014 6-21
Configuring the 802.1x Protocol Using the Configuration Files
You use the following parameters to configure the 802.1x Protocol on your phone using the configuration files.
For EAP-MD5 use:
• eap type
• identity
• md5 password
• pc port passthrough enabled
For EAP-TLS use:
• eap type
• identity
• 802.1x root and intermediate certificates
(use 1 root and 0 or 1 intermediate certificates)
• 802.1x local certificate
(use 1 local certificate)
• 802.1x private key
(1 private key that corresponds to local certificate)
• 802.1x trusted certificates
(0 or more trusted certificates (a maximum of 2)
Configuring the 802.1x Protocol Using the IP Phone UI
Use the following procedure to configure the 802.1x Protocol on your phone using the IP Phone UI.
Configuration Files
For the specific parameters you can set in the configuration files for setting 802.1x support, see Appendix A, the section, “802.1x Support Settings” on
pageA-94.
Note:
If configuring 802.1x using the IP Phone UI, the certificates and private keys must already be configured and stored on
the phone. Use the configuration files or the Aastra Web UI to load certificates and private keys.
IP Phone UI
1.
Press to enter the Options List.
2. Select Administrator Menu and enter your Administrator password.
3. On 11-Line LCDs:
Select Network Settings->Ethernet & VLAN->802.1x Settings.
On 3-Line LCDs:
Select Network Settings->Ethernet & VLAN->802.1x Settings.
4. Select 802.1x Settings.
5. Select 802.1x Mode.