Filter
Top Products
Network Settings
4-18 41-001343-02 REV04 – 05.2014
Configuring Network Settings Manually
If you disable DHCP on your phone, you need to configure the following network settings manually:
• IP Address
• Subnet Mask
• Gateway
• Primary DNS
• Secondary DNS
You can configure the network settings using the configuration files, the IP phone UI, or the Aastra Web UI.
Errors Messages Display when Incorrect Network Settings Entered
The IP Phone UI AND the Aastra Web UI immediately notify the Administrator if an incorrect value is being entered for
the following network parameters in the IP Phone UI and the Aastra Web UI:
• A 0.0.0.0 entered as values for the IP Address, Subnet Mask and Gateway parameters
• IP Address and Gateway IP address parameter values entered exactly the same
• Gateway IP address and the IP address parameter values configured on the same subnet
If you configure the Gateway parameter and the IP Address parameter on the same subnet, the following error message
displays:
“Gateway IP address and the IP address parameter values configured are not on the same subnet”.
Note:
If you disable DHCP on the phone, the phone uses the TFTP protocol as the default server protocol. If you want to spec-
ify a different protocol to use, see “Configuration Server Protocol” on page4-87.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Network Settings” on pageA-8.
IP Phone UI
1.
Press on the phone to enter the Options List.
2. Select Administrator Menu.
3. Enter your Administrator password.
Note:
The IP Phones accept numeric passwords only.
4. Select Network Settings.
5. Select IP Address and enter the IP address of the phone.
6. Select Subnet Mask and enter the subnet mask.
7. Select Gateway and enter the gateway address.
8. Select DNS and enter a Primary and/or Secondary DNS server.
9. Press Done to save the changes.
The IP phone is manually configured.