Filter
Top Products
Operational, Basic, and Advanced Parameters
41-001343-02 REV04 – 05.2014 A-24
Multiple Configuration Server Settings
Additional Information
The directory files, language packs, TLS certificate files, 802.1x certificate files, and HTTPS files can also be downloaded to
the phone from a server other than the configuration server. For each of these types of files, you can specify a URL (server
IP address) from which the phone gets these files. You can use existing parameters on the phone to specify the URL. For
more information about this feature, refer to Chapter 1, the section, “Directory Files, Language Packs, TLS Certificates,
802.1x Certificates, HTTPS Files and Multiple Configuration Servers” on page1-53.
For information on configuring the directory, language pack, TLS certificates, 802.1x certificates, and HTTPS parameters,
see the applicable parameters in this Appendix.
Parameter –
firmware server
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Specifies either a full or partial URL of a server (other than the original configuration
server) from which the phones in the network get their firmware.
Note:
The default method for the update of firmware to the phones is from the original con-
figuration server. The Administrator must specify a correct server URL for the phones to
get their firmware information from that server. If the URL is incorrect, no firmware
download occurs to the phones from the specified server.
Format String (up to 256 characters)
FTP
“ftp://username:password@0.0.0.0:port/path”
TFTP
“tftp://0.0.0.0:port/path”
HTTP
“http://0.0.0.0:port/path”
HTTPS
“https://0.0.0.0:port/path”
Partial URL
“/path”
Default Value Blank
Range Not Applicable
Example firmware server:
Leaving this parameter blank downloads all configuration and firmware files from the
original configuration server.
firmware server: tftp://10.30.102.158/test1
The above example uses TFTP to download all firmware files that exist in the “test1”
directory on the specified server, to the phones.
firmware server: /path
The above example uses the configuration server that is linked to the partial path to load
the firmware.