Toshiba CTX28 Telephone User Manual


 
Strata CTX
Configuration
Strata CTX Configuration
Primary/Reserve Power Cabinet Hardware
Strata CTX I&M 06/04 2-49
Primary/Reserve Power Cabinet Hardware
The type of cabinet mounting can have an effect the power requirements. There are two types of
mounting for the CTX100 and CTX670 (listed below).
Cabinet Wall Mounting – The lightweight and compact design of CTX100 and CTX670
enables easy wall mounting. Wall Mounting requires no special hardware.
Cabinet Floor Mounting – Only the CTX670 can be floor mounted (requires the BFIF
hardware kit). If floor mounting three or more cabinets, AC and reserve power must be
connected to the BCCB conduit connection box option by a licensed electrician. If more than
two cabinets require reserve power batteries, the BBDB must be installed.
Underwriters’ Laboratory (UL) and local electrical codes require certain standards for connecting
commercial AC and reserve power to the Strata CTX system. Tables 2-63 and 2-66 describe which
assemblies may be required to meet UL and local electrical code standards.
The power distribution hardware for the CTX100 is shown in Table 2-65.
Table 2-63 CTX670 Reserve Power Characteristics
Battery Charger Characteristics Maximum Battery Charger Drain (-24VDC)
Charger: current limiting
Nominal float voltage: 2.275 volts/cell
Charge current: 0.7 amps maximum
Battery discharge cut-off voltage: 20.5 ±0.5VDC
1 cabinet
2 cabinets
3 cabinets
4 cabinets
6.0 amps
12.0 amps
18.0 amps
24.0 amps
5 cabinets
6 cabinets
7 cabinets
30.0 amps
36.0 amps
42.0 amps
Table 2-64 CTX670 Typical Reserve Power Duration Estimates
1
1. Assumes 80 ampere-hours with 12VDC batteries.
Number of Cabinets 1 2 3 4 5 6 7
Estimated operation time
Two-battery configuration
12.0 hr. 6.0 hr. 4.0 hr. 3.0 hr. 2.5 hr. 2.0 hr. 1.8 hr.
Estimated operation time
Four-battery configuration
24.0 hr. 12.0 hr. 8.0 hr. 6.0 hr. 5.0 hr. 4.0 hr. 3.5 hr.
DC Current Drain
(-24VDC)
4.6
amps.
8.7
amps.
12.8
amps.
16.9
amps.
21.0
amps.
25.1
amps.
29.2
amps.
Table 2-65 CTX100 Cabinet Power Distribution Hardware
Option Description
APSU112
Strata CTX100 cabinet power supply is supplied with each cabinet. Operates with 120VAC as
the system’s primary power source and requires 1.8 amps AC per cabinet.
The power supply AC cord is 5 ft. long with a standard three prong plug.
ABTC-3M
A three-meter long battery cable is used to connect reserve power batteries to the ABCS battery
charger when the system has less than three cabinets. One reserve power cable is required for
each cabinet.
ABCS
Option battery charger that is installed on the APSU112 power supply. One per cabinet is
required with the ABTC-3M if connecting reserve power batteries to the CTX100.