Toshiba CTX28 Telephone User Manual


 
Station Apparatus
2000-series Telephones
Strata CTX I&M 06/04 11-57
Station Apparatus
³ To toggle full/half-duplex mode
³ Press button 10 (see Figure 11-41) to turn full-duplex mode On or Off.
Full-duplex mode: Button 10 LED Off.
Half-duplex mode: Button 10 LED On.
Notes
Button 10 functions the same for Internal and/or External Microphone.
If DIP switch 6 and 7, in Figure 12, are turned Off, the Full/half-duplex function of Button 10
is disabled.
The DKT2020-FDSP’s full-duplex operation depends on the speaker volume setting. Raising
or lowering the speaker volume directly affects the performance of the full-duplex operation.
Important!
If raising or lowering the volume does not improve performance, switch to half-duplex mode by
pressing Key 10.
If both you and the distant party are using full-duplex speakerphones, the sensitivity to both
echo paths may cause a reduction or instability of volume. If this happens, it may be necessary
to switch to half-duplex mode by pressing key 10.
Digital Single Line Telephone (DKT2001 only)
For instructions on installing the DKT3001 SLT, see “Digital Telephone System Connection” on
page 11-2.
DKT 2001 Installation
1. Set the DIP switches to match Figure
11-42. The DIP switches are preset from
the factory for the USA and Canada.
Refer to Table 11-10 on page 11-52 for
other country settings.
2. If required to achieve maximum
distance (greater than 1000 ft.), install a
two-pair house cable (or external
power).
3
4
82
4
1
ON
2
3
4
Figure 11-42 DKT2001 DIP Switch Settings