Toshiba CTX28 Telephone User Manual


 
Station Apparatus
Tilt Stands
Strata CTX I&M 06/04 11-23
Station Apparatus
Tilt Stands
This section explains how to attach desktop tilt stands to 3000-series or 2000-series digital DKTs,
the IPT1020-SD or to a DSS console. Use Tilt Stand model “BTSD” (not BTSA) with a standalone
DKT, IPT or DSS.
³ To attach a Tilt Stand to a 3000-series DKT, IPT1020-SD or DSS
1. Plug the phone jack into the bottom of the phone or DSS console.
2. Slide the Address Tray out, then gently squeeze the tray and remove it (see Figure 11-16).
3. Pull the top of the Tilt Stand so that it’s open at an angle.
4. Slide the Tilt Stand into the former Address Tray holder. (The Stand should catch under the
front tray holder notches.) Push Stand in until it snaps into place (see Figures 11-17 and 11-18).
5. Push in the Lock Release to adjust the tilt angle (0, 10, 20 or 30 degrees, see Figure 11-19).
6. Insert the Address Tray back into its holder.
Figure 11-16 Bottom View of Telephone Figure 11-17 Slide Tilt Stand into Address Tray Slot
Notice:
If you change the tilt stand angle, hold the telephone
in your hand when you push the release button so the
unit does not fall onto the stand.
Figure 11-18 Tilt Stand “Snaps” In Figure 11-19 Telephone on a Tilt Stand
5448
Plug in
phone jack
Squeeze and
slide out the
address tray
5846
5847
5848
Lock Button
Release