Filter
Top Products
Strata CTX670 Installation
Install Reserve Power
Strata CTX I&M 06/04 4-37
Strata CTX670
Installation
Bolt Cabinets to Wooden Floor
1. Mount the CTX670 Base Cabinet on Floor
Mount Fixtures (BFIF). See Figures 4-19
and 4-20.
2. Position the Base Cabinet at the selected
installation location.
3. Mark the floor where holes will be drilled.
Move the Base Cabinet prior to drilling.
Note Cover the Base Cabinet with a drop cloth
to protect the power equipment from
dust created during drilling.
4. Drill pilot holes to make insertion of 3/8
inch lag bolts easier, and to prevent splitting
of wood flooring.
5. Move the Base Cabinet into position on the
equipment room floor.
6. Secure the Base Cabinet to the floor using lag bolts, lock washers, and flat washers.
Bolt Cabinets to Computer Room Floor
1. Mount the CTX670 Base Cabinet on Floor Mount Fixtures (BIMF). See Figures 4-19 and 4-20.
2. Position the Base Cabinet at the selected installation location.
3. Mark the floor where holes will be drilled. Move the Base Cabinet prior to drilling.
Note Cover the Base Cabinet with a drop cloth to protect the power equipment from dust created
during drilling.
4. Drill holes through tile for 3/8-inch threaded rods.
5. After the tiles have been drilled, insert threaded rods through the holes in the tile and mark the
concrete floor directly beneath the holes in the tiles.
6. Remove the tiles. Use a hammer drill to make holes for 3/8-inch bolt anchors.
7. Install the bolt anchors with plugs in the
drilled holes.
8. Using the driving tool and a hammer, drive
each bolt anchor into the floor.
9. Screw threaded rods into each bolt anchor.
10. Install a hex nut, lock washer, and flat
washer on each threaded rod. Screw the
nuts down far enough to allow floor tiles to
be replaced over the threaded rods.
11. Replace tiles over threaded rods in their
original positions on the floor.
12. Reach under the tiles, and screw the hex
nuts upward until the flat washers are
touching the bottom of the tile.
13. Use a hack saw to cut the threaded rods at a
height of approximately 1.5 inches above the floor tile.
14. Move the Base Cabinet into position over the threaded rods.
Wooden
Floor
BFIF
(Floor
mount
fixture)
Base
Cabinet
Bolt
Lockwasher
1468
Figure 4-22 Installation on Wooden Floor
Floor Tiles
Lead Anchors
Concrete
Flat Washer
Lock Washer
Hex Nut
BFIF
(Floor
mount
fixture)
Bottom
Cabinet
1469
Figure 4-23 Installation on Computer Room