Toshiba CTX28 Telephone User Manual


 
ISDN Interfaces
RBSU/RBSS Interface Units
7-22 Strata CTX I&M 06/04
A cord of up to 10 meters connects the ISDN BRI RJ45 wall jack to the desktop TE-1 or TA RJ45
jack. Bellcore recommends that all TE-1 and TA devices be attached with the same standard cord
to ensure compatibility.
Figure 7-15 Modular ISDN Data Cable
The standard pinouts for ISDN jacks is the TIA-568A or TIA-568B jack as listed in Table 7-11.
The variants A and B to the TIA specification are electrically the same, only the wire colors are
different. However, you should only use one type TIA jack in a customer installation because
mixing the two may cause certain wire pairs to be swapped which would result in line faults.
Notes
Pins are numbered left to right when looking into the jack cavity with the locking tab down.
TIA-568A swaps pair two with pair three, changing only the color of the wires on the pins.
Electrical performance is the same.
Table 7-11 TIA-568B (RJ45) Jack – ISDN Standard Interface Modular Connector Pinout (RBSU-
NT mode
Pin Color Name Function
1 Green T2 Power 3 (not used on RBSU/RBSS)
2 Green/White R2 Power 3 (not used on RBSU/RBSS)
3 Orange/White R3 RX+
4 Blue/White R1 TX+
5Blue T1TX-
6 Orange T3 RX-
7 Brown T4 - Power 2 (not used on RBSU/RBSS)
8 Brown/White R4 + Power 2 (not used on RBSU/RBSS)
3039
Four-pair Wire
RJ-45
Eight-pole Plug
Locking Tab