Filter
Top Products
IP Telephony and QSIG Over IP
Pre-installation Guidelines
Strata CTX I&M 06/04 9-9
IP Telephony and QSIG
Over IP
2. Use the supplied Ethernet
10/100Base-T (straight-through cable)
with an RJ45 connector (eight pin
jack) to connect to the telephone LAN
jack (see Figure on right).
3. Connect the other end of the telephone
LAN cord to the LAN or server (see
Figures 9-3 and 9-8.)
4. The IPT operates like a switch, as
opposed to a hub, so the IPT can be
connected directly to the LAN and
then a PC can be connected to the IPT
PC jack to make a connection to the
LAN.
5. Use the same type of RJ45 cable
connector used in the previous step to
connect the IPT to the PC.
Notes
• A new Add-on Module (ADM) (part
number DADM3120) can be
connected to the IP telephone. The
DKT3000 ADM is not compatible
with the IPT. The installation is the
same as for the older model DADMs.
See “Digital Add-on Module
Installation” on page 11-21 for
installation instructions.
• For details on other IPT options, see “Power over LAN” on page 9-16. If Power over LAN is
used, the AC adapter should not be installed and vice versa.
IPT Operation Notes
The following provides information IPT operation with Strata CTX systems (see Table 9-3).
Table 9-3 IPT1020-SD Operation with Strata CTX
IPT1020-SD Buttons and Features Strata CTX System with BIPU
Basic LCD 2 x 24 characters
LCD Feature button Operational
Fixed Spdial button Operational
IPT1020-SD telephones per cabinet slot 16 telephones max.
Programming Mode “A” (Beep Tone On/Off, etc.)
Program Mode “A” is for telephone options that are
controlled by the ROM inside the telephone.
Not Operational
DC12V
_
+
LAN PC
HEADSET
AC Adapter
Connects
to LAN Switch,
Router
Power
Over LAN
Connects
to PC
Built in
Headset
or HESB
Interface
6682
Figure 9-3 IPT Connections