Toshiba CTX28 Telephone User Manual


 
Strata CTX100-S/CTX100 Installation
Installing the CTX100 Cabinet
3-18 Strata CTX I&M 06/04
Replacing the Power Supply
1. Make sure that the power supply switch is Off and that the AC power cable is not plugged into
an outlet.
2. Set the power supply in its proper place in the cabinet (see Figure 3-16).
3. Secure the power supply to the cabinet with the screws.
4. Connect the green/green-yellow wire from the AMAU motherboard to the FG screw on the
power supply.
5. Plug the DC cable into the CN OUT connector.
6. Install the ABCS battery charger.
7. Plug in the reserve battery cable to the CN-BAT connector of the ABCS battery charger.
8. Plug in the AC power cord connector into the AC-IN plug.
9. Insert and tight the two screws in front of the power supply (see Figure 3-15).
10.Plug the BASE/EXP jumper plug into the appropriate BASE or EXP connector on the power
supply (see Figure 3-14).