Toshiba CTX28 Telephone User Manual


 
Strata CTX100-S/CTX100 Installation
Installing the CTX100 Cabinet
3-6 Strata CTX I&M 06/04
Installing the CTX100 Cabinet
Step 1: Remove Cabinet Covers
1. Loosen the screws from the front cover to remove it.
2. Loosen the four screws from the top cover and slide it off.
3. Loosen the four screws from each side cover and pull the
covers forward to remove them.
Step 10: Remove the Back Cover from the Cabinet(s)
1. Remove and save the two screws from the back of the Base Unit.
2. Slide the metal cover about a half inch to the right (it will drop down and forward) to remove it.
3. If you are installing an Expansion Cabinet, remove one screw from the back of the Expansion
Cabinet. Slide the metal cover to the right to remove it.
Note The figure below show the position of the screws. Back covers should be removed before
the Base and Expansion cabinets are attached to each other.
Figure 3-4 Base and Expansion Cabinet Back Covers
WARNING! Ensure the power supply AC plug is not
plugged into the AC outlet.
6074
Figure 3-3 Cabinet Cover
Removal
Remove 1 screw
EXPANSION BASE
5933