Toshiba CTX28 Telephone User Manual


 
Station Apparatus
Tilt Stands
11-24 Strata CTX I&M 06/04
Tilt Stand Installation with Add-on Modules
This section explains how to attach a tilt stand to a digital or IP telephone with one or two ADMs.
Follow the instructions for the appropriate number of ADMs. Use Tilt Stand model “BTSA” (not
“BTSD”) for telephones with one or two ADMs.
³ To attach a digital or IP telephone with one ADM to a Tilt Stand
1. Complete the steps under “To install DADMs” on page 11-21.
2. Make sure bottom phone jack is plugged in.
3. Remove Tilt Stand from Tilt Stand Base (see Figure 11-21).
4. Place the spacers on the outer holes, as shown (see Figure 11-22).
5. Attach Tilt Stand to bottom of telephone with screws (see Figure 11-20).
6. Reinstall the Tilt Stand Base: Fit the Tilt Stand Base over the Tilt Stand so that the “bottom
pegs” fit into the holder. Adjust Tilt Stand so that the “top pegs” fit into the top Tilt Stand Base
holes (see Figure 11-21). Do this to both stands.
7. Pull up on the Tilt Stand Bases so that they open to the maximum angle (30 degrees).
8. Push in the Release button to adjust the tilt angle (0, 10, 20 or 30 degrees) of each Tilt Stand.
Figure 11-20 Attach Tilt Stands to DKT/IPT and One ADM
6506
1 PHONE
1 ADM
PHONE PHONE
PHONE
Spacer
Spacer
2 ADM
2 ADM
1 ADM
1 ADM
2 ADM
1 ADM
2 ADM
1 ADM
2 ADM
1 ADM
2 ADM
PHONE
PHONE
1 ADM + 1 DKT (or 1 IPT)
Put in three screws in the
positions marked “PHONE.”
Insert a spacer beneath each stand as shown. Put in the
screw with the spacer first. Then insert the other two screws.
Put in three screws in the
positions marked “1ADM.”
ADM
DKT/IPT