Filter
Top Products
Rack Mount Cabinets
Step 3: Install Remaining Cabinet(s)
5-8 Strata CTX I&M 06/04
Step 2D: Reattach Cabinet to Base
Note Skip this step if you did not perform Step 2B.
³ Using the two screws removed in “Step 2B: Take Off Base of Cabinet” on page 6, reattach the
cabinet to the base.
Step 3: Install Remaining Cabinet(s)
Step 3A: Take Off Front and Back Covers
1. Unscrew the two screws holding the front cover to the unit and slide the cover off.
2. Unscrew the four screws holding the back cover to the unit and take the cover off.
Step 3B: Install and Attach Cabinet(s) to Rack
Note See “Step 2C: Attach Cabinet to Rack” on page 5-6 for special instructions on positioning
the cabinets before attaching.
1. Place the base of the next cabinet 10.5 inches from the base of the upper base/expansion cabinet
(as shown below).
2. Screw the cabinet flange to the rack using two screws on each flange (four total).
6U = 10.5 inch or 267 mm
Start (see Fig. 4-3)
Start (see Fig. 4-3)
7101