Filter
Top Products
CTX28 Installation
Installing the CTX28 Cabinet
Strata CTX I&M 06/04 1-7
CTX28 Installation
3. Place the Base KSU on the desired
location on the mounting surface and
mark the location of the four screw
holes. See Figures 1-4 and 1-5.
4. Using a hard board between the KSU
and the wall, secure the hard board to
the wall first, making certain that screws
are aligned with studs. See Figure 1-5.
5. Drill holes on these marks and secure
screws approximately two thirds of the
way into the top two holes on the
mounting surface.
6. Hang the unit from the top two screws
and then secure the top screws
completely into the mounting surface.
7. Finish securing the unit to the mounting
surface by completely screwing the
bottom two screws into the wall.
Figure 1-5 KSU Wall Mounting
8. Ground system according to “AC Power and Grounding Requirements” on page 1-4.
7104
Figure 1-4 CTX28 Base KSU Interior
Method 2
Stud
Plaster
Board
Hard Board
(1/2 Inch Plywood)
Base KSU
7114