Filter
Top Products
Revision History
Date of revision Manual No.
Revision details
Nov. 2013 IB(NA)1501127-A
First edition created.
Jun. 2014 IB(NA)1501127-B
- The words "detector" were replaced by "encoder".
- "Precautions for Safety" was revised.
- Function Specifications List was revised.
- "Environmental Conditions" in "Installation of Servo Motor" was revised.
- "Installation of Spindle Motor" was revised.
- "Installation of Tool Spindle Motor" was revised.
- "Installation of the Drive Unit" was revised.
- "Main Circuit Terminal Block/Control Circuit Connector" was revised.
- "Connection of Tool Spindle Motor" was revised.
- "Emergency Stop Observation" was revised.
- "STO (Safe Torque Off) Function" was revised.
- "Setting the Initial Parameters for the Servo Drive Unit" was revised.
- "List of Standard Parameters for Each Spindle Motor" was revised.
- "Spindle Parameters" was revised.
- "OMR-FF Function" was revised.
- "Servo Control Signal" was revised.
- "Adjusting the Acceleration/Deceleration Operation" was revised.
- "Spindle motor temperature compensation function" was added.
- "Spindle Control Signal" was revised.
- "Protective Functions List of Units" was revised.
- "Troubleshooting" was revised.
- "Replacing the Fuse" was revised.
- "Power Backup System" was revised.
- "Cable and Connector Specifications" was revised.
- "D/A Output Specifications for Drive Unit" was revised.
- "Precautions in Installing Spindle Motor" was deleted.
- "Higher Harmonic Suppression Measure Guidelines" was revised.
- Miswrite is corrected.