Filter
Top Products
Appendix 2 - 5
MDS-D2/DH2 Series Instruction Manual
Appendix 2.1 CMV1-xPxxS-xx Plug Connector
Angle back shell
[1] Fix the 2 surface width of the angle back shell on the tightening guide.
[2] Set the back shell wrench adjusting to the 2 surface width of the back shell coupling.
[3] With the wrench, tighten the back shell coupling to the angle back shell.
Recommended tightening torque: 4 to 5N.m
(Note 1)) When setting the work to the wrench, adjust it to the 2 surface width.
To remove, take the reverse steps.
(Note 2) To change the back shell angle, adjust the toothing position of the plug shell and back shell.
(Note 3) Manufactured by DDK
Contact: Fujikura Ltd. http://www.fujikura.co.jp/eng/
(8) Insert a busing and a cable clamp
Insert the bushing and the cable clamp in the back shell.
(Note) After the Bushing insert, confirm that cable position should be inside of Bushing.
(9) Tightening a clamp nut
Straight back shell
[1] Temporarily tighten the clamp nut on the straight back shell.
*To prevent the loosening, it is recommended to coat the straight back shell with adhesive.
Recommended adhesive: 1401B (Three Bond Co., Ltd.)
[2] Fix the 2 surface width of the straight back shell on the tightening guide.
[3] With the wrench, tighten the clamp nut on the straight back shell.
Recommended tightening torque: 4 to 5N•m
(Note 1) When setting the work to the wrench, adjust the 2 surface width.
To remove, take the reverse steps.
(Note 2) Manufactured by DDK
Contact: Fujikura Ltd. http://www.fujikura.co.jp/eng/
15
19
Torque wrench
Tighten
(Back shell width)
Angle back shell
Tightening guide
* Referential dimensions for back
shell tightening guide
٨Recommended jigs and tools : Back shell wrench (357J-51333T)
Bit (357J-51344T)
Torque wrench (CL6N x 8D,Tonichi Mfg.)
Back shell
coupling
Set
Set
* Recommendation:
Tightening guide
(357J-52658T)
Angle back shell
wrench
* Recommended tightening guide: (357J-53402T) (Note 3)
(Note 3)
Cable clamp
Cable
Bushing
Back shell
Insert
Cable
Cable clamp
Bushing
Back shell
Insert