Filter
Top Products
2 - 44
2 Wiring and Connection
MITSUBISHI CNC
< Servo drive unit >
【#2233】 SV033 SSF2 Servo function 2
bit D : rps Safely limited speed setting increment
Change the setting units of the specified speed signal output speed (SV073) and safely limited
speed (SV238).
0: mm/min 1: 100mm/min
【#2273(PR)】 SV073 FEEDout Specified speed output speed
Set the specified speed.
Also set SV082/bit9,8 to output digital signal.
---Setting range---
0 to 32767 (r/min)
However, when SV033/bitD=1, the setting range is from 0 to 32767(100mm/min).
【#2282】 SV082 SSF5 Servo function 5
bit 9-8 : dos2 Digital signal output 2 selection
00: Disable 01: Specified speed output
< Spindle drive unit >
【#13018(PR)】 SP018 SPEC2 Spindle specification 2
bit 8 : spsu Command speed limit value
0: 33,750 r/min 1: 135,000 r/min
【#13030】 SP030 SDT2 2nd speed detection setting value
Set the specified speed of the specified speed output.
When carrying out digital output of the specified speed output, set SP229/bitC to "1".
---Setting range---
0 to 32767 (r/min)
【#13229】 SP229 SFNC9 Spindle function 9
bit C : sdt2 Specified speed output digital signal 2 output
0: Normal 1: Enable