Filter
Top Products
4 - 118
4 Setup
MITSUBISHI CNC
【#3107】 ori_spd Orientation command speed
Set the spindle speed during orientation command.
When the spindle is not running or running to the different direction with the orientation, the
orientation is carried out with this speed after a stop. When the spindle is running to the same
direction with the orientation, this parameter does not have a meaning because it decelerates
directly and the orientation is carried out.
---Setting range---
1 to 99999 (r/min)
【#3108】 ori_sft Position shift amount for orientation
The orientation stop position can be moved by this parameter setting although normally the position
is Z -phase position.
During multi-point orientation control, the stop position is determined by the total value of this
parameter and the position data for multi-point orientation of PLC input.
---Setting range---
-35999 to 35999 (0.01°)
【#3109】 zdetspd Z phase detection speed
For the first S command after power is turned ON, the spindle rotates at the speed of setting value
for this parameter until Z phase is detected twice.
When "#3106/bitF = 1" (Spindle zero point proximity switch detection enabled), also proximity switch
is detected.
(Note) When spindle zero point proximity switch detection is enabled, the rotation direction of the
orientation/zero point return (synchronous tapping, spindle/C axis) will follow Z phase detection
direction. And the speed will follow Z phase detection speed.
---Setting range---
1 to 99999 (r/min)
【#3110】 tap_spd Synchronous tapping zero point return speed
Set the zero point return speed during synchronous tapping control.
---Setting range---
1 to 99999 (r/min)
【#3111】 tap_sft Synchronous tapping zero point return shift amount
Set the zero point return shift amount during synchronous tapping control. Zero point angle shifts
from Z phase according to the setting angle.
---Setting range---
0 to 35999 (0.01°)
【#3112】 cax_spd Spindle C axis zero point return speed
Set the zero point return speed during spindle C axis control.
---Setting range---
1 to 99999 (r/min)
【#3113】 cax_sft Spindle C axis zero point return shift amount
Set the spindle C axis zero point return shift amount. Zero point angle shifts from Z phase according
to the setting angle.
---Setting range---
0 to 359999 (0.001°)