Filter
Top Products
Appendix 2 - 8
Appendix 2 Cable and Connector Assembly
MITSUBISHI CNC
Appendix 2.2 1747464-1 Plug Connector
Appendix 2.2.1 Applicable Products
Appendix 2.2.2 Applicable Cable
Refer to Product Specification and Application Specification for details.
Appendix 2.2.3 Related Documents
Appendix 2.2.4 Assembly Procedure
Assemble the cable in the following procedure:
(1) Insert accessories to the cable.
(2) Remove the sheath of the cable jacket and core wires referring to the typical
dimensions in the right figure.
Do not damage the core wires. Retry it if the core wires are partly cut off or
damaged.
The length of mesh shield should be decided referring to the right figure and be
turned up on the outside of a jacket.
(Note) Even when the dimensions above is applied,
product performance problem can occur depending on the wires which is used.
Be sure to contact with the sales department of the manufacturer below if you consider to adopt this
connector.
Tyco Electronics Japan G.K. http://www.te.com/en/home.html
(3) Twist a copper foil tape with conductive adhesive of width 5mm around the mesh
shield.
Cable finish outside diameter: Φ7.3 to 7.7
(4) Refer to Application Specification (114-5335) and crimp the contacts. After crimping,
check the state in accordance with the Specification.
Part No. Descriptions
1674320-1
1674320-2
Encoder cable I/O kit
1674335-4 Receptacle contact
Wire conductor size Cable jacket outside diameter
#26-22AWG 6.8 - 7.4 mm
No. Details
108-5864 Product Specification
114-5335 Rec, Contact Application Specification
114-5338 Ground Clip Application Specification
Receptacle case assembly
Wire clamp
Wire fixed set screw
Wire rubber packing
Ground clip
Cable
14mm
16mm
45mm
1.62.0mm
1.62.0mm
Mesh shield
Far side
Near side
6mm MAX
Φ7.37.7
Copper foil tape
Receptacle contact